MAIN MENU
31
6) ALARM BUZZER
Select to enable or disable the sound when any internal alarm is triggered (ON / OFF).
7) HDD BUZZER
Select to enable or disable the sound (ON / OFF) when the HDD remaining capacity reaches to the value set
in “HDD NEARLY FULL (GB)”.
8) ALARM DURATION (SEC)
Select the duration time for alarm buzzer in second (5 / 10 / 20 / 40).
9) HDD NEARLY FULL (GB)
If HDD BUZZER is enabled, select the duration time for buzzer notifications when the hard disk available
capacity is 5/10/15/20 GB left.
10) HDD OVERHEAT ALERT (°C)
Select the temperature alert for your hard disk to be aware of the possible overheat of your hard disk.
5.4.4 NETWORK
NETWORK
S
S
T
T
A
A
T
T
I
I
C
C
ADVANCED CONFIG
CAMERA WAN FTP E-MAIL
DDNS
DETECTION NETWORK TYPE STATIC
ALERT IP 192.168.001.010
NETWORK GATEWAY 192.168.001.254
DISPLAY NETMASK 255.255.255.000
RECORD PRIMARY DNS 168.095.001.001
DEVICES SECONDARY DNS 139.175.055.244
DCCS PORT 0080
IVS APPLY
NOTIFY
EXIT MAC: 00:0E:53:EC:A7:B4
1) NETWORK TYPE
Select the network type as STATIC and set all the information needed in the DVR.
2) NETWORK INFORMATION (IP / GATEWAY / NETMASK)
Key in all the network information obtained from your ISP (Internet Service Provider).
3) DNS (PRIMARY DNS / SECONDARY DNS)
Key in the IP address of the domain name server obtained from your ISP (Internet Service
Provider).
4) PORT
The valid number ranges from 1 to 9999. The default value is 80. Typically, the TCP port used by
HTTP is 80. However in some cases, it is better to change this port number for added flexibility or
security.
To Next Page
Loading...
Need help?
General
