Connector Pin Assignments
Installation Guide - Model 60E 11
4 - CONNECTOR PIN ASSIGNMENTS
This chapter describes the connector pin assignments for the different ports of
the AX3000 Model 60E.
4.1 - ETHERNET PORT RJ45 (10BT)
Recommended wiring is a non-shielded twisted-pair cable (UTP), category 3
or 5
1 2 3 4 5 6 7 8
RJ45 connector (Model 60E rear panel)
Note: the maximum length of a 10Base-T cable is 100 meters (330 feet).
Pin Signal Name Direction
1 TX+ (Transmitted Data) Input
2 TX- (Transmitted Data) Input
3 RX+ (Received Data) Output
4 --- ---
5 --- ---
6 RX- (Received Data) Output
7 --- ---
8 --- ---
a - AX3000 Connected to a HUB
2
3
2
3
6
TX+
11
TX-
RX+
RX-
TX+
TX-
RX+
RX-6
<
>
>
<
(*) see the note on next page
(*)
AX 3000 Model 65E HUB
To Next Page
Loading...
Need help?
General