Quick Installation
8 Installation Guide - Model 60E
- Enable DHCP: two possible values:
- yes: the DHCP protocol is run when the set-up is exited. The
DHCP function is automatically set to get both the AX3000 IP
address and other DHCP options (netmask, default router, etc).
- no: parameters are manually entered (in addition, AX3000 Name
(FQDN) is not accessible).
- AX3000 IP address: it must be entered if DHCP is disabled.
- Default router: optional router IP address.
- 1st DNS Server IP Address: optional DNS server IP address
- AX3000 Name (FQDN): this optional parameter (see appendix A.5)
allows an AX3000 to be identified by this name if both a DHCP server
and a Dynamic DNS server are available.
- Windows Host Name: if the IP address of a host is not given, this name
will be resolved by DNS (if a DNS server is given).
- Windows IP address: if this field is left blank, DNS will be used to
resolved the hostname.
- Enable: selecting an LPD printer attached to AX3000.
- Printer Name (accessible only if "Enable" is set): this is the LPD printer.
After confirmation, all the AX3000 set-up parameters are updated.
3.2 - INTERACTIVE SET-UP
All the AX3000 set-up parameters (network environment, session settings and
auxiliary port settings) can be adjusted through this interactive set-up.
Use the following keystroke combination to enter the interactive set-up:
Note: this chapter deals only with the RDP configuration procedure. For more
information (DNS, router, auxiliary ports, etc.), please read the AX3000
TCP/IP - User's Manual.
To Next Page
Loading...
Need help?
General