AXELL OPTICAL MASTER UNIT MARK II
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd Doc PN 00018UM Rev. 1.9 V
Caution: Safety to
personnel.
• Before installing or replacing any of the equipment, the entire
manual should be read and understood.
• The user needs to supply the appropriate AC or DC power to the
equipment. Incorrect power settings can cause damage to the
equipment and cause injury to the user.
• Please be aware that the equipment may, during certain conditions
become very warm and can cause minor injuries if handled without
any protection, such as gloves
•
All servicing must be carried out by certified servicing engineers.
Caution: Safety to
equipment
• When installing, replacing or using this product, observe all safety
precautions during handling and operation. Failure to comply with
the following general safety precautions and with specific
precautions described elsewhere in this manual violates the safety
standards of the design, manufacture, and intended use of this
product.
• Axell Wireless assumes no liability for the customer's failure to
comply with these precautions. This entire manual should be read
and understood before operating or maintaining the remote.
•
All servicing must be carried out by certified servicing engineers.
Attention: Electrostatic
Sensitivity
Observe electrostatic precautionary procedures.
ESD = Electrostatic Discharge Sensitive Device.
Semiconductor transmitters and receivers provide highly reliable
performance when operated in conformity with their intended design.
However, a semiconductor may be damaged by an electrostatic
discharge inadvertently imposed by careless handling.
Static electricity can be conducted to the semiconductor chip from the
centre pin of the RF input connector, and through the AC connector
pins. When unpacking and otherwise handling the remote, follow ESD
precautionary procedures including use of grounded wrist straps,
grounded workbench surfaces, and grounded floor mats.
Caution: Class 1 Laser
Equipment described in this manual are equipped with class 1 lasers, as
per definition in EN 60825-1
Caution - Un-terminated optical receptacles may emit laser radiation.
Exercise caution as follows:
• Do not stare into beam or view with optical instruments. Optical
transmitters in the fibre optic converter can send out high energy
invisible laser radiation. There is a risk for permanent damage to
the eye.
• Always use protective cover on all
cables and connectors which are
not connected.
• Never look directly into a fibre cable or a connector.
• Consider that a fibre can carry transmission in both directions.
• During handling of laser cables or connections, ensure that the
source is switched off.
• Regard all open connectors with respect and direct them in a safe
direction and never towards a reflecting surface. Reflected laser
radiation should be regarded as equally hazardous as direct
radiation.
To Next Page
Loading...