Axis 200 - Page 21

AXIS 200 User’s Manual Section 3: Assigning an Internet Address
19
Procedures
Choose one of the following methods to download the Internet
address to your AXIS 200.
Using ARP in
Windows 95 and
Windows NT
Follow these instructions to download the Internet address and verify
the communication.
Start a DOS window and type the following commands:
Example:
The host will return ‘
Reply from 192.168.3.191 ...
’ or some
similar message. This indicates that the address has been set and the
communication is established.
Important!
Windows 95 only: if the ARP table is empty, you must first ping an
existing unit on your network before setting the Internet address of
your AXIS 200. Type
arp -a
to display the ARP table.
Note that if your AXIS 200 unit is connected to the Windows 95
client via a hub, without network connection to other devices, you
must use the command
arp -s <Internet address> <Ethernet
address> <client address>
where
<client address>
is the
Internet address of your Windows 95 client.
Note:
❏ When you execute the
ping
command for the first time, you will
experience a significantly longer response time than usual.
arp -s <Internet address> <Ethernet address>
ping <Internet address>
arp -s 192.168.3.191 00-40-8c-10-00-86
ping 192.168.3.191