Appendix B: The Parameter List
AXIS 200 User’s Manual
64
Factory Default Settings
If you should need to reset the AXIS 200 to its factory default settings,
you can use the Control button. Follow these steps:
1. Switch off the AXIS 200 by unplugging the power cord.
2. Press and hold the Control button while you switch on the AXIS
200. Keep the Control button pressed until the Snapshot
indicator flashes at regular two second intervals.
3. Release the Control button and wait at least two seconds (one
flash of the Snapshot indicator).
4. Press and hold the Control button for at least five seconds until
the Snapshot indicator remains constantly lit.
5. If you need to restore the default Internet address, press and hold
the Control button once again until the Snapshot indicator starts
flashing. Otherwise, the Internet address setting remains
unchanged.
6. The AXIS 200 is now reset to factory default settings. Restart the
AXIS 200 by switching it off and on.
Note:
❏ The node address (NODE_ADDR parameter) remains
unchanged, but all other parameters are reset.
To Next Page
Loading...
