Axis 200 - Page 23

AXIS 200 User’s Manual Section 3: Assigning an Internet Address
21
Using RARP in UNIX
Follow these steps to use the RARP method in UNIX:
1. Append the following line to your Ethernet address table. This is
typically performed using the command
/etc/ethers
:
Example:
2. If necessary, update your host table and alias name databases as
described required by your system.
3. If it is not already running, start the rarp daemon. This is typically
performed using the command
rarpd -a
4. Restart the AXIS 200 to download the Internet address.
<Ethernet address> <host name>
00:40:8c:10:00:86 cameraname