Axis
Owners
Manual
2019
Page 79
DO NOT USE AUTOMOTIVE JUMPER CABLES TO START
THE ENGINE. Never jump-start the boat from a vehicle on-shore
or another boat. The presence of water and fumes create a situation in
which sparks or backre could result in serious injury or even death.
Engine Sensors
To ensure the engine runs as designed, it is equipped with several sensors that constantly
monitor engine functionality. These sensors include:
• Oil temperature sensor
• Oil pressure sensor
• Manifold absolute pressure (MAP)
• Camshaft position sensor
• Crankshaft position sensor
• Coolant temperature sensor
• Knock sensor
These sensors are inaccessible to consumers because they are located inside sealed por-
tions of the engine. Sophisticated, expensive tools are necessary to analyze the sensor activity;
therefore, if any of the sensors indicates malfunction, the boat needs to be presented to the
authorized Axis dealer for diagnosis and resolution of any issues that may be present. Notice of
potential malfunctions will appear on the video screen. (See Video Screen section of this Owner’s
Manual for more detail.)
Additionally, alarms may sound if issues arise aecting engine operation. These alarms may
be visual on the video screen or may be audible alarms. Although it is possible for a sensor to be
in error, it is unlikely. Experience has shown over the years that the sensors are highly accurate
and oer protective warnings of malfunction that could potentially bring attention before more
expensive and damaging events occur. Never ignore an alarm! Seek assistance from your autho-
rized Axis dealer if the issue cannot be resolved or recurs.
Never ignore visual or audible alarms! Consumers may be able to
address the issue raised by the alarm, but if the alarm persists, cease
operating the boat and seek assistance from your authorized Axis
dealer. Failure to seek aid in analyzing the cause of an alarm could
result in damage that is not covered under warranty. Some alarms could be for malfunctions that could
also put individuals on-board in potential harm.
other
electrical components
All boats have 12-volt receptacles for your convenience. Some models have
more than one receptacle. Verify locations with your authorized Axis dealer. It is the
responsibility of the device user to determine that the accessory is designed to be
operated on a 12-volt system. If the connector will not easily and securely insert into
the 12-volt receptacle, do not force it. If damage occurs to the device or the boat’s
electrical system by attempting to use a device that is not compatible, such damage
will not be covered under warranty nor will Axis accept responsibility.
12-volt
receptacle
To Next Page
Loading...
Need help?
General
