Axis
Owners
Manual
2019
Page 80
There is a breaker board in the port rear closeout adjacent to the engine
compartment. The black board contains four (4) breakers. If the Power Wedge II will
not operate, verify that the supplemental breakers located in the port rear storage
compartment are properly set.
A waterproof Surf Band is an
option for Axis models. Worn on the wrist of a
wake-surfer, wakeboarder or skier, the device
allows redundant control of the
Surf Gates, Power Wedge and minor
cruise control adjustments. The
boat operator still has primary con-
trol of the boat and can deactivate
the rider controls.
The Surf Band turns ON and OFF
through the SETTINGS menu on the
12.3” video screen.
The distance from the boat that the Surf Band is operational is approximately 80
feet. The signal emitted from the wristband will weaken as distance from the boat
increases, but the cessation of operation will vary, depending on conditions, location,
battery strength, and other factors.
To operate the Surf Band while underway:
1. Place the Surf Band securely on the wrist of your non-dominate hand.
2. To adjust the Power Wedge, press the UP ARROW to raise the Power Wedge.
Press the DOWN ARROW to lower the Power Wedge.
3. To adjust the Surf Gates, press the LEFT ARROW (<) above the word “Surf” to surf left (in-
crease the wave on the left, or port, side of the boat). Press the RIGHT ARROW (>) to surf right
(increased the wave on the right, or starboard, side of the boat).
4. To increase the speed of the boat, press the UP ARROW above the word “Speed.” To reduce
speed, press the DOWN ARROW.
The Surf Band will TEMPORARILY override the driver’s control of
these elements of the boat operation. However, you should be aware
that the driver can always resume control of all aspects at any time.
Surfers should limit the amount of time spent looking at the wristband
as prolonged viewing away from the boat, wave, and surroundings could result in the surfer losing
control and falling from the suroard. Injury could result.
The Surf Band communicates over a commonly used radio frequency.
The command signals may not be successfully sent or received
when subjected to radiated interference from nearby high-powered
transmitters operating on the same frequency. The possibility of
interference is minimal, but it is unavoidable.
If the signal LED stops ashing with a button press, or communication becomes intermittent,
replace the battery:
1. Rotate the battery cover counterclockwise one-eighth (1/8) of a turn with a coin or screw-
port rear
breaker
board
surf
band
To Next Page
Loading...
Need help?
General
