Axis Q6000-E Mk II - Calibrate the PTZ network camera

AXISQ6000-EMkIIPTZNetworkCamera
Getstarted
IPaddress-EntertheIPaddressforthePTZnetworkcamera.
Ports-EntertheportnumberusedforthecommunicationwiththePTZnetworkcamera.Usethedefaultvaluesormodifyasper
requirement.
Autoconnect-CheckthisboxfortheproducttoautomaticallyconnecttothePTZnetworkcamerawhennetworkconnectionis
established.Thismaybeusefulifforexampletheproducthasrestartedduetopowerfailure.
Tosavethesettings,clickSave.
CalibratethePTZnetworkcamera
Important
IfPTZcameraandthecameraheadsarenotcalibrated,thePTZfunctionswillnotworkasexpected.
Note
•IftheAxisproductlosesconnectionwiththePTZcamera,re-connectfromSystemOptions>PTZNetworkCamera>
Connection.
•ClickonPTZNetworkCameraConnectionOKtoaccessthePTZcamera’swebpages.
TocalibratethePTZcamera,dothefollowing:
1.InthePTZNetworkCameraCalibrationpage,selectachanneltocalibrate.
2.AddacalibrationpointintheselectedchannelthennavigatethePTZcameratondthesamepointinthePTZcameraview.
3.ClickSave.
4.Repeatsteps2-4untiltherearefourcalibrationpointsinthechannel.
Toimprovecalibrationaccuracy,makesurethe4calibrationpointsarespreadevenlyovertheimageandatleastone
calibrationpointisclosertothecenteroftheimage.Itisnotrecommendedtoaddpointsneartheedgesoftheimage.
5.Repeatthesameprocedureforallchannels.
6.SelectFinishCalibration.
9