Need help?Do you have a question about the Axis V5925 and is the answer not in the manual?
General| Type | IP security camera |
|---|---|
| PTZ control | Yes |
| Certification | 55032 Class A, EN 55035, EN 61000-3-2, EN 61000-3-3, EN 61000-6-1, EN 61000-6-2, FCC Part 15 Subpart B Class A, ICES-3(A)/NMB-3(A), VCCI Class A, RCM AS/NZS CISPR 32 Class A , KC KN32 Class A, KC KN35, IEC/EN/UL 62368-1, CAN/CSA C22.2 No. 62368-1, KC-Mark, IEC 60068-2-1, IEC 60068-2-2, IEC 60068-2-6, IEC 60068-2-14, IEC 60068-2-27, IEC 60068-2-78, NIST SP500-267 |
| Placement supported | Indoor |
| Connectivity technology | Wired |
| Bit rate control | Variable Bit Rate (VBR) |
| Total megapixels | - MP |
| Maximum resolution | 1920 x 1080 pixels |
| Supported video modes | 1080p |
| Image quality adjustment | Brightness, Saturation, Sharpness |
| Video compression formats | AVC, H.264, H.265, HEVC, M-JPEG, MPEG4 |
| Supported graphics resolutions | 160 x 90, 1920 x 1080 (HD 1080) |
| Digital zoom | 12 x |
| Optical zoom | 30 x |
| Number of lenses | 1 |
| Focal length range | 4.4 - 132 mm |
| Maximum aperture number | 4.6 |
| Minimum aperture number | 1.4 |
| Sensor type | CMOS |
| Optical sensor size | 1/2.8 \ |
| Pan range | -170 - 170 ° |
| Pan speed | 100 °/sec |
| Tilt angle range | -20 - 90 ° |
| Camera shutter speed | 1/10000 - 1 s |
| Minimum illumination | 0.03 lx |
| Wi-Fi | - |
| Streaming method | Multicast |
| Ethernet interface type | Fast Ethernet |
| Supported network protocols | IPv4/v6, HTTP, HTTP/2, HTTPS , SSL/TLS , QoS Layer 3 DiffServ, FTP, CIFS/SMB, SMTP, Bonjour, UPnP, SNMP v1/v2c/v3 (MIB-II), DNS, DynDNS, NTP, RTSP, RTP, SFTP, TCP, UDP, IGMP, RTCP, ICMP, DHCPv4/v6, ARP, SOCKS, SSH, SIP, LLDP, MQTT, Syslog, HDMI 1.4, 3G-SDI |
| Form factor | Dome |
| Mounting type | Ceiling/wall |
| Product color | Black, White |
| Housing material | Plastic |
| Sample rate | 48 kHz |
| Audio formats supported | AAC-LC, ADPCM, LPCM |
| Security algorithms | 802.1x RADIUS |
| Flash memory | 512 MB |
| Compatible memory cards | MicroSD (TransFlash), MicroSDHC, MicroSDXC |
| Power source type | DC |
| Power consumption (max) | 25 W |
| Power consumption (typical) | 14 W |
| Storage temperature (T-T) | -40 - 65 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Operating relative humidity (H-H) | 10 - 85 % |
| Harmonized System (HS) code | 85258900 |
Weight and Dimensions| Width | 136 mm |
|---|---|
| Height | 180 mm |
| Weight | 1500 g |
Guides installers in fine-tuning the camera view during setup.
Locates devices, lists browsers, and provides access steps to the web interface.
Steps to establish a secure password for initial device login and security recommendations.
Procedures to ensure the device has original firmware and security integrity.
Configuration of capture mode, mounting, power line frequency, and orientation.
Steps for replacing the lens and adjusting image parameters.
Guides on adjusting zoom, focus, and using focus recall areas.
Optimizing latency, exposure modes, night mode, IR illumination, and noise reduction.
Enabling VISCA control via IP or serial connection.
Viewing, recording video, and reducing bandwidth/storage usage.
Connecting monitors, setting up network storage, and recording video.
Creating rules to automate actions based on specific events.
Setting up recordings or text overlays triggered by object detection.
Integrating PIR detectors for motion detection and wiring instructions.
Integrating PIR detector and gate switch for automated access control.
Accessing and navigating the device's web interface, status, and security.
Viewing and configuring video input, PTZ status, and connected clients.
Controls for live video streaming, including pan, tilt, zoom, and focus.
Configuration settings for installation, image correction, and PTZ calibration.
Adjusting scene profiles, saturation, contrast, brightness, and sharpness.
Controlling wide dynamic range, contrast, and white balance.
Configuring network settings, including IP, hostname, DNS, and access protocols.
Configuring IEEE 802.1x, brute-force attack prevention, and IP address filtering.
Enabling SSH and performing maintenance like restart and firmware upgrade.
Resetting to factory defaults, firmware options, checking version, and upgrading.
Solutions for technical issues, firmware upgrades, IP address problems, and browser access.
To Next Page
