Axon Fleet 3 Wireless Microphone Installation and User Manual
Axon Enterprise, Inc. Page 19 of 28
Lapel Mic Plugged In
Control: Plug your Lapel Mic accessory into the right side of your Wireless Mic.
When plugged in, the LCD shows a mic icon next to the signal strength bars. Unplugging the Lapel
Mic removes the icon.
Battery Exceeds Thermal Limits
When the microphone’s battery is too hot or too cold to operate, you’ll enter a thermal shutdown
mode. If the microphone is undocked then it will shut off immediately. If the microphone is docked
then you’ll see the following warning on its display. Thermal limits are exceeded:
• If above 80C
• If below -21C
Control:
Blinking yellow LEDs, LCD shows icon indicating temperature is too extreme
To Next Page
Loading...
