EasyManua.ls Logo

Axxess AX-ADBOX2 - Connections to be Made; Aftermarket Radio Connections; Navigation Built-in Connections

Axxess AX-ADBOX2
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation instructions for AX-ADBOX2
METRA. The World’s best kits.
metraonline.com1-800-221-0932
© COPYRIGHT 2004-2014 METRA ELECTRONICS CORPORATION
REV. 10/17/2014 INSTAX-ADBOX2
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
IMPORTANT WARNING
Thisproductincludesinstructionsforinstallation
whichmustbecarefullyfollowed.Theinstructionsare
wordedinsuchamannertoassumethattheinstalleris
capableofcompletingthesetypeofelectronicinstallations.
Ifyouareunclearastowhatyouareinstructedtodoor
believethatyoudonotunderstandtheinstructionssoasto
properlyandsafelycompletetheinstallationyou
should consult a technician who does have this
knowledge and understanding.
Failure to follow these instructions carefully and
to install the interface as described could cause harm
to the vehicle or to safety systems on the vehicle.
Interference with certain safety systems could cause
harm to persons as well. If you have any questions in
this regard please call the Help line or Metra at
1-800-221-0932 for assistance.
Connections to be made
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connectthe(2)Redwirestotheignition/accessorywire.
• ConnecttheOrange/Whitewiretotheilluminationwire.Iftheaftermarketradiodoesnothave
anilluminationwire,tapeofftheOrange/Whitewire.
• ConnecttheBlue/Whitewiretotheampturnonwire(thiswiremustbeconnectedtohearsound
fromthefactoryamplifier).
• ConnecttheBrownwiretothemutewire.IftheaftermarketradiodoesnothaveaMutewire,
tapeuptheBrownwire.
For aftermarket radios with navigation built-in
• ConnecttheLight Greenwiretotheparkingbrakewire
• ConnecttheBlue/PinkwiretotheV.S.S.orspeedsensewire
• ConnecttheGreen/Purplewiretothereversewire.
Note: For the remaining wires, please refer to the instructions supplied with the required
wiring harness.

Related product manuals