2-15
2-6-5. Auto-setup
Perform Auto-setup normally as per the instructions on page 3-1 through page 3-2
(perform the manual Zero-span adjustment on page 3-3 if necessary). When an SVP is
attached to a rotary actuator, Zero and Span are sometimes set in reverse. Use a Commstaff
to manually set the Actuator to the correct action (Direct or Reverse) as per the steps on page
4-10.
If after Auto-setup, the SVP exhibits excessive overshooting (hunting), decrease the actuator
parameter as per the steps on page 4-11.
Perform Auto-setup by referring to page 3-1 through 3-3 “Auto Setup, Zero-Span
Adjustment”
To Next Page
Loading...