5-2
5-1-2. Operating procedure
The technique for switching the A/M switch is shown below.
Switching from automatic (normal) operation to manual operation
Use a flat-bladed screwdriver to turn the A/M switch once fully in the counterclockwise.
Do not loosen this screw
Fig. 5-2. Switching from automatic (normal) operating state to manual operating State
Note) Do not loosen the A/M switch cover plate screw.
Switching from manual operation to the automatic operation
Use a flat-bladed screwdriver to turn the A/M switch in the clockwise direction until it
stops.
Do not loosen this screw
Fig. 5-3. Switching from manual operating state to automatic operating state
To Next Page
Loading...