iii
Unpacking
Handle the equipment with all due care to prevent any damage to prevent damage.
Verify that the following items are included:
Smart Valve Positioner 100 Series Model AVP100 (1) / AVP102(1)
Feedback lever (1) and hex socket bolt (2).
Hex wrench (1) for feedback
Pressure gauge (option)
Joint (option)
Manual (option)
Storage
When storing your SVP without its original packaging, store it indoors, at normal
temperature (25°C) and humidity (~65%) store it in a place free from vibration and shock
and not exposed to rain or water.
If you are storing your SVP after it has been used, clean the SVP thoroughly and then
firmly tighten the terminal box cover and seal the wiring, piping connections and bleed
hole on the pilot cover using Azbil Corporation-supplied caps or tape to prevent entry of
moisture.
Precautions for worker safety
Do not stand on the installed SVP or use it as a step.
Take utmost care not to in voluntarily touch the SVP while it is in operation. Its surface
may be very hot or very cold, depending on the operating environment.
To Next Page
Loading...