Press Simple Connect for two seconds on HomePlug Y. After you release the button,
the Power LED will blink. If the Power LED did not blink, press Simple Connect
again for two seconds.
Note: Do not press Simple Connect for more than two seconds.
Press the Simple Connect button for two seconds on HomePlug X. After you release
the button, the Power LED will blink. If the Power LED did not blink, press the
Simple Connect again for two seconds.
Pairing between two devices are only given two minutes upon pressing the Simple
Connect button for two seconds on HomePlug Y. After pressing the Simple Connect
on HomePlug Y, make sure to press the Simple Connect button of HomePlug X within
two minutes to ensure a successful connection, otherwise repeat steps 2 and 3 until
the LEDs of both devices switch OFF and on twice, indicating that they are paired
successfully with one another.
Note: Do not press Simple Connect for more than two seconds
To Next Page
Loading...
Need help?
General
