User Manual
Page 23 of 40
Power Saving Mode
After 15 minutes of Ethernet inactivity, HomePlugAV will enter Power Saving Mode.
The Power LED will start BLINKING slowly to indicate its Power Saving Status.
Conditions of a HomePlugAV on a Power saving mode:
- Power LED is blinking slowly
- Powerline Activity LED and Ethernet LED are turned OFF.
- When connected to a PC or Laptop, if there is network card inactivity,
HomePlugAV is also on a Power Saving mode.
Note: If another device is on a Power Saving Mode, the HomePlugAV Utility may
detect the device but would be unable to configure its respective setting.
To Next Page
Loading...
Need help?
General
