User Manual
Page 36 of 40
Remote Private Network Name
Without leaving your computer, you can change the Private Network Name of
remote HomePlugAV devices, provided they are using the same Private Network
Name as your local HomePlugAV. You cannot change the Private Network Name of
remote devices that is not currently networked with your local HomePlugAV.
Note: When changing the Private Network Name of remote devices, you will need
the Device ID that appears on the label pasted on the device. It will be more helpful
if you list down the Device ID of all your HomePlugAVs to enable you to remotely
change their settings using the HomePlugAV Web User Interface.
To change the Private Network Name of a remote HomePlugAV:
1. Open the Web User Interface,
2. Click Network, then go to Powerline Settings.
3. Go to Remote Device Configuration.
4. Enable Security
5. Type the Device Name (If any).
6. Enter the Remote MAC Address of the other HomePlugAV.
7. Enter the Device Password. The Device Password can be found on the label
sticker on each respective device.
To Next Page
Loading...
Need help?
General
