User Manual
Page 55 of 68
Port Triggering
This page is used to configure the port-triggering rule.
Enabled: Enable or disable the port-triggering rule.
Application Name: Set the application name.
Trigger Ports: The triggering ports are used for the applications generating the
connection requests. Only the applications generate the connections on the ports,
all the ports of the incoming port type will open, otherwise, the incoming ports will
not open.
Trigger Protocol: Set the protocol for the virtual service. You may select All, TCP
or UDP.
Incoming Ports: After the applications generate the connections on the triggering
ports successfully, the corresponding port will open. The applications can generate
To Next Page
Loading...
Need help?
General
