BAC FXV - Introduction; Safety; Shipping; Pre-Rigging Checks

WWW.BALTIMOREAIRCOIL.COM
2
CROSSFLOW COIL PRODUCTS
Introduction
1
Safety
Adequateprecautionsappropriatefortheinstallationandlocationoftheseproductsshould
betakentosafeguardtheequipmentandthepremisesfromdamageandthepublicfrom
possibleinjury.The procedures listed in this manual must be thoroughly reviewed prior to
rigging and assembly. Read all warnings, cautions, and notes detailed in the margins.
Whenthefanspeedoftheunitistobechangedfromthefactorysetspeed,includingthe
useofavariablespeeddevice,stepsmustbetakentoavoidoperatingatornearthefan’s
“criticalspeed”whichcouldresultinfanfailureandpossibleinjuryordamage.Consult
withyourlocalBACRepresentativeonanysuchapplications.
Shipping
FXV,FXV3,CXVB,andCXVTunitsarefactory-assembledtoensureuniformqualitywith
minimumeldassembly.Singleairintakemodelsshipintwosectionspercell(lowerand
upper).Dualairintakemodelsshipinfoursectionspercell(onelowerandthreeupper:
eachcoilsectionshipsseparately)tominimizeriggingandfreightcosts.Contactyourlocal
BACRepresentativeformoreinformation.Forthedimensionsandweightsofaspecicunit
orsection,refertothecertieddrawings.
Pre-Rigging Checks
Whentheunitisdeliveredtothejobsite,itshouldbecheckedthoroughlytoensureall
requireditemshavebeenreceivedandarefreeofanyshippingdamagepriortosigningthe
billoflading.
The following parts should be inspected:
 SheavesandBelts
 Bearings
 BearingSupports
 FanMotor(s)
 FanGuard(s)
 Fan(s)andFanShaft(s)
 FloatValveAssembly(s)
 WaterDistributionSystem
 CoilSurface
 ColdWaterBasinAccessories
 InteriorSurfaces
 ExteriorSurfaces
 Louvers/CombinedInletShields
 SprayWaterPumps
 MatingSurfacesBetweenSections/
Modules
 MiscellaneousItems:Allbolts,
nuts,washers,andsealertape
requiredtoassemblesectionsor
componentpartsarefurnishedby
BACandshippedwiththeunit.
Achecklistinsidetheenvelope
attachedtothesideoftheunit
marked“Contractor’sInstallation
Instructions”indicateswhat
miscellaneouspartsareincluded
withtheshipmentandwherethey
arepacked.
WARNING: Failure to use lifting
provisions can result in a dropped
load causing severe injury, death,
and/or property damage. Lifts
must be performed by qualified
riggers following BAC published
Rigging Instructions, and generally
accepted lifting practices. The
use of a supplemental safety
sling may also be required if the
lift circumstances warrant its
use, as determined by the rigging
contractor.
CAUTION: Only personnel qualified
to do so should undertake
operation, maintenance and repair
of this equipment. Proper care,
procedures and tools must be used
in handling, lifting, installing,
operating, maintaining and
repairing this equipment to prevent
personal injury and/or property
damage.