WWW.BALTIMOREAIRCOIL.COM
3
Unit Weights
Beforerigginganyunit,theweightofeachsectionshouldbeveriedfromtheunitcertied
drawing.Unitprintweightsincludethenalassembledunitwithallaccessories.Accessory
weights(foundontherespectivedrawing)canbedeductedfromthetotalweight.
Anchoring
Seven-eighthsinch(7/8”)diameterholesareprovidedinthebottomangeofthebasin
sectionforboltingtheunittothesupportbeams.Refertothesuggestedsupportdrawing
includedinthesubmittalforlocationandquantityofthemountingholes.The unit must
be level for proper operation.Anchorboltsmustbeprovidedbyothers.TheIBCratingis
onlycertiedwithstandardanchoragelocations.Usingalternateanchoragelocationsor
alternatesteelsupportswillvoidanyIBCwindorseismicratings.ContactyourlocalBAC
Representativefordetails.
Cold Weather Operation
Theseproductsmustbeprotectedbymechanicalandoperationalmethodsagainstdamage
and/orreducedeffectivenesswheneveraunitisoperatedinbelowfreezingambient
conditions.PleaserefertotheCrossflow Coil Product Operation and Maintenance Manual
onwww.BaltimoreAircoil.com,orcontactyourlocalBACRepresentativeforrecommended
coldweatheroperationstrategies.
Location
Allevaporativecoolingequipmentmustbelocatedtoensureanadequatesupplyoffresh
airtotheunitairintakes.Whenunitsarelocatedadjacenttowallsorinenclosures,
caremustbetakentoensurethewarm,saturated,dischargeairisnotdeectedand
recirculatedbacktotheairintakes.
Eachunitshouldbelocatedandpositionedtopreventtheintroductionofdischarge
airintotheventilationsystemofanybuilding.FordetailedrecommendationsonBAC
equipmentlayout,seeourwebsiteatwww.BaltimoreAircoil.comorcontactyourlocalBAC
Representative.
Warranties
PleaserefertotheLimitationofWarranties(locatedinthesubmittalpackage)applicableto
andineffectatthetimeofthesale/purchaseoftheseproducts.
Unit Operation
Priortostart-upandunitoperation,refertotheCrossflow Coil Product Operation &
Maintenance Manual shippedwiththeunitandalsoavailableatwww.BaltimoreAircoil.com
Introduction
Safety
Shipping
Pre-Rigging Checks
Unit Weights
Anchoring
Cold Weather Operation
Location
Warranties
ATTENTION: Before an actual lift
is undertaken, ensure no water,
snow, ice, or debris has collected
in the basin or elsewhere in the
unit. Such accumulations will add
substantially to the equipment’s
lifting weight.
NOTE: Each unit must be located
and positioned to prevent the
introduction of discharge air
into the ventilation systems of
the building on which the unit is
located and of adjacent buildings.