Bacharach Portable Combustion Analyzer - Configuring the PCA

Setup
3.4 Configuring the PCA
PCA
The PCA is configured at the factory for the parameters shown below.
These parameters, however, can be changed by following the instructions
in their associated sections.
Function Parameters To Change,
Refer to . . .
Fuel Natural Gas Section 4.8
Temperature º C Section 4.13
Draft W C Section 4.14
Oxygen Reference 0 % Section 4.15
Language English Section 4.16
Display Mode CO & NX Section 4.17
Time HR:MIN:SEC AM/PM Section 4.18
Date MM/DD/YY Section 4.18
3-4 Instruction 0024-9219