5
-
32
PRECAUTIONS FOR HANDLING IMPLEMENT
ROTAVATOR
▶
Safety precautions for rotavator
● Never remove the safety cover of
the rotavator.
● Do not remove the PTO shaft cov-
er and safety cover on the univer-
sal joint.
● When adjusting each part, disen-
gage the PTO and stop the engine
in advance.
● When driving on a road, keep the
PTO disengaged. Also, keep the
rotavator lowered on a road as
long as it does not hit the ground.
● For the universal joint, its inner
shaft and outer shaft should be
overlapped at least 15 cm.
● Check that the universal joint is
rmly xed to the tractor and rota-
vator shaft.
•
Read instructions on warn-
ing decals on each implement
thoroughly before work.
•
To avoid an injury due to mis-
handling of an implement,
read the user’s manual of the
implement thoroughly and
work safely and precisely with
caution.
•
Installation of an improper im-
plement can lead to an injury.
Install only implements speci-
ed by the Manufacturer.
WARNING
1. When driving the tractor to attach
or detach an implement, make
sure that there is no one in be-
tween or around the tractor and
implement.
2. Install and remove the implement
only on safe and level ground.
3. When engaging a heavy imple-
ment, load the weight on the front
to keep the balance of the tractor.
4. When adjusting an implement, ap-
ply the parking brake, stop the en-
gine and set the PTO switch in the
OFF position in advance.
5. To tow anything, use the towing-
hitch only.
2024h_3026h.indb 322024h_3026h.indb 32 2020-09-18 오후 6:17:272020-09-18 오후 6:17:27
To Next Page
Loading...
Need help?
General
