6
-
12
►REPLACEMENT
1. Open the radiator cap and the
drain plug to completely drain the
water from the radiator.
2. Rinse the radiator with tap water
until no dirt or rust comes out.
※
For better results, fill the radia-
tor with water mixed with radiator
flush, run the engine for over 15
minutes, and drain the water solu-
tion
3. Assemble the drain plug, add an-
ti-freeze and fill the radiator with
tap water.
4. Assemble the radiator cap and run
the engine to mix the anti-freeze
and water.
•
Do not open the radiator
cap while the engine is run-
ning or right after the engine
is stopped. Open the radia-
tor cap only after the engine
is stopped and fully cooled
down.
[Otherwise]
Hot water will splash and may
cause burn injury
DANGER
COOLANT
►CHECKING
Open the engine hood and the side
cover and see if the water level in the
reservoir is between the upper and
lower limit. Add clean water as nec-
essary.
(1) Radiator Cap
2024h_3026h.indb 122024h_3026h.indb 12 2020-09-18 오후 6:17:312020-09-18 오후 6:17:31
To Next Page
Loading...
