Badger Meter M Series - Page 35

Page 35
4-11
Installation & Operation Manual
Inputs/Outputs
Digital Output Preset Amount
[0.0]
S
Preset amount lets you set the reset value for the associated PS totalizer when the
digital input is set to Batch Reset.
To change the preset amount, follow these steps from the Inputs/Outputs Menu:
1. Select Digital Output 1, 2, 3 or 4 and press [E] to open the Digital Output
menu.
2. From the Digital Output menu select Preset Amount, and press [E] to open
the Preset Amount display.
3. Enter the preset amount value. Press [E] to save the new parameter and return
to the Digital Output menu.
Note: You can only set one Preset Amount. If you set the Preset Amount for
Digital Output 1, it will be the same for 2, 3 and 4.
Set Point Min.
[0%]
S
This parameter establishes, as a percentage of full scale flow, the threshold at which
the output alarm will be activated. Flow rates below the threshold will activate the
output alarm.
To change the set point minimum, follow these steps from the Inputs/Outputs
Menu:
1. Select Digital Output 1, 2, 3 or 4 and press [E] to open the Digital Output
menu.
2. From the Digital Output menu select Set Point Min., and press [E] to open the
Set Point Min. display.
3. Enter the set point minimum value. Press [E] to save the new parameter and
return to the Digital Output menu.
Set Point Max.
[100%]
S
This parameter establishes, as a percentage of full scale flow, the threshold at which
the output alarm will be activated. Flow rates above the threshold will activate the
output alarm.
To change the maximum set point, follow these steps from the Inputs/Outputs
Menu:
1. Select Digital Output 1, 2, 3 or 4 and press [E] to open the Digital Output
menu.
2. From the Digital Output menu select Set Point Max., and press [E] to open
the Set Point Max. display.
3. Enter the set point maximum value and press [E] to save the new parameter
and return to the Digital Output menu.