Configuration / setup
Page 6 AC_F110_BA_02_1346 November 2014
6.3 Scrolling through SETUP
6.3.1 SELECTION OF FUNCTIONS GROUP AND FUNCTION
SETUP level is divided into several function groups and functions.
Select a function group with
Select a function with
Each function has a unique number, which is displayed below the word "SETUP" at the bottom of the display. The number is a
combination of two figures. The first figure indicates the function group and the second figure the sub function. Additionally,
each function is expressed with a keyword.
After selecting a sub function, the next main function is selected by scrolling through all "active" sub functions (e.g. 1, 11,
12, 13, 14, 1, 2, 3, 31 etc.).
6.3.2 TO CHANGE OR SELECT A VALUE
a) Press briefly; PROGRAM starts flashing
b) Select or enter value with and / or
c) Press, to confirm the value.
To change a value, use to select the digits and to increase that value. To select a setting, both and can be used. If
the new value is invalid, the increase sign or decrease sign will be displayed while you are programming.
When data is altered but ENTER is not pressed, then the alteration can still be cancelled by waiting for 20 seconds or by
pressing ENTER for three seconds: The PROG procedure will be left automatically and the former value reinstated.
NOTE: Alterations will only be set after ENTER has been pressed!
To Next Page
Loading...
