ORI-AS-00036-EN-06
Destination Settings
Field Description for ORION SE Gateway
Backhaul Type WiFi
Destination IP Customer-supplied Internet Protocol (IP) address used to identify the gateway.
Destination Port Customer-supplied port destination setting. ORION SE default setting is 5004.
Connection Int. (s) Customer-supplied connection interval setting which defines how often the gateway connects to
the reading data management system. ORION SE default setting is 30 seconds.
Keep-Alive Int. (m) Customer-supplied setting which defines how often the gateway sends a message to the reading
data management system to stay connected. ORION SE default setting is 9 minutes.
Gateway IP Settings
Field Description for ORION SE Gateway
DHCP Enabled Field automatically fills with information from the network. Remove the check mark in the box to
change the settings in this section.
IP Address Customer supplied. Can be changed based on the network settings.
Subnet Mask Customer supplied. Can be changed based on the network settings.
Gateway Address Customer supplied. Can be changed based on the network settings.
WiFi Settings
Field Description for ORION SE Gateway
SSID The name of the WiFi network.
Security Open; WEP; WPA-PSK; WPA2-PSK.
Key Index Index of the key being used. Applies to WEP only.
Passkey Security passkey – customer defined.
Backhaul Identification
Field Description for ORION SE Gateway
Version Read only field. Fills with the WiFi backhaul version number.
Module ID(s) Read only field. Fills with the Module ID of the WiFi backhaul connection.
The Reload button refreshes the information in the fields.
Using the Software
Page 24 April 2015
To Next Page
Loading...
Need help?
General