ORI-AS-00036-EN-06
USING THE SOFTWARE
The configuration software is used to view and configure the gateway settings. The software includes the following screens for
gateway configuration and security:
• Gateway Information
• Gateway Network Configuration
• Gateway Identification
• Gateway Firmware Update
MPORTANTI
The gateway transceiver/receiver must be ON (power supply connected) when you use the configuration software.
Launching the Software
OTE:N Make sure the computer with the installed software is
connected to the gateway before launching the software. See
“Connecting to the Gateway” on page 10 if you need help.
Click the Gateway Configure software desktop shortcut icon to launch
the software application.
Figure 15: Desktop shortcut
Exiting the Software
When the gateway configuration is complete, click the X in the top right corner of the screen to close the software application
and disconnect the gateway from the computer.
Using the Software
Page 13 April 2015
To Next Page
Loading...
Need help?
General