Interrupting and Ending the Batch Process
When you press HOLD, the batch process is temporarily interrupted; the actual values are not lost. The word "HOLD" flashes
on the display. From this point, you can press START to resume the batch process.
You can end the batch process entirely at any time by pressing RESET.
OTE:N The actual values are lost and the system returns to steady state. The batch cannot be resumed.
Figure 21: Example display information when interrupted
Additional key functions:
Flow rate indication During batching, the actual flow rate will display after pressing the RATE key. To
return to the main display: press RATE again or wait for 20 seconds.
Display total and accumulated total When the TOTAL key is pressed once, the resettable total will display. After
pressing this key again, accumulated total will display.
The accumulated total cannot be reinitialized. The value will count up to
9,999,999,999. The unit and number of decimals are displayed according to the
configuration settings for preset. To return to the main display: press TOTAL
again or wait for 20 seconds.
Clear total The value for total can be reinitialized. To do so, select TOTAL and press RESET:
the flashing text "PUSH RESET" will display.
To avoid reinitialization at this stage, press a key other than RESET or wait for 20
seconds. If RESET is pressed again, TOTAL will be reset to zero.
Reinitialization of total DOES NOT influence the accumulated total.
OTE:N Total can only be reset if no batch process is active (status: READY).
OTE:N This function might not be available due to configuration settings.
Display batch counter The number of completed batches is displayed after pressing COUNT. To return
to the main display: press COUNT again or wait for 20 seconds.
Clear batch counter The value batch counter can be reinitialized. To do so, select COUNT and press
RESET: the flashing text "PUSH RESET" will display.
To avoid reinitialization at this stage, press a key other than RESET or wait for
20 seconds. If RESET is pressed again, COUNT will be reset to zero.
OTE:N COUNT can only be reset if no batch process is active (status: READY).
OTE:N This function might not be available due to configuration settings.
User Manual
Page 19 April 2017 CTL-UM-00483-EN-07
To Next Page
Loading...
Need help?
General
