17
OPERATION
CUSTOMER MANUAL FRONT HUB MOTOR SYSTEM
5.5 Switching the electrical
system on and off
Make sure that the pedals of your Pedelec are
not weighed down when the system is turned
on. Any load on the pedals as it is switched on
may lead to power restrictions and error
messages. When this happens, switch off the
system and turn it on again.
Conditions
In order to activate and use your Pedelec, the
following prerequisites must be fulfilled:
• A sufficiently charged battery must be used.
• The battery must be inserted correctly into
the battery holder.
• The motor, control unit, control unit/battery,
etc. must all be connected correctly.
You can switch the electrical system of your Pe-
delec on and off according to the description on
the control unit, see section "Control element".
If the battery of your Pedelec is equipped with an
on/off switch, you can also press the switch on
the battery.
Battery switch On-Off
If you press the switch again, the system will be
turned off.
To Next Page
Loading...
