BAFANG BT C01.340.UART - E08.UART Usual Operation; E08.UART Power Control; E08.UART Battery Level Indication; E08.UART Light Control

19
DP E08.UART
CUSTOMER MANUAL FRONT HUB MOTOR SYSTEM
6.3 Usual operation
6.3.1 Power ON / OFF
Press for 2 seconds, the display will turn ON;
press for 2 seconds, the display will turn OFF.
It will turn off automatically after five minutes of
standby.
6.3.2 State of charge indication
5 LEDs indicate the state of charge, if the lowest
LED flickers, it means it is time to charge the
battery.
LED indication definition
(from bottom to top)
State of
Charge
5
> 75 %
4
50 % – 75 %
3
30 % – 50 %
2
10 % – 30 %
1
< 10 %
1 flickers
≤ 5 %
6.3.3 Light ON / OFF
Press
for 2 seconds, LED display dims, then
the front and rear light will be turned on at the
same time.
Press
a second time for 2 seconds, LED display
lights up, then front light and rear light will be
turned off. (if the lights cannot be operated
manually, restart the display and then the lights
will revert to automatic operation).
6.3.4 Push-assistance
Push-assistance function may only be used
when pushing the e-bike. Risk of injury when
the wheels of the e-bike do not have ground
contact while using the push-assistance
function.
Press for 2 seconds, the push assistance will
be turned ON, and the LED level will flicker. If
you remove your finger from this button, the
push-assistance will be turned OFF.