BAFANG DP C15.UART - Error Code Definition

11
DISPLAY MANUAL DP C15.UART
ERROR CODE DEFINITION
This HMI DP C15.UART can indicate all errors
occurring on the pedelec.
Error Explanation Troubleshooting
03 Brakes enabled Check whether a brake cable is stuck.
07 High voltage protection
Bring your Pedelec to your dealer or to a
specialist to have the error fixed.
08 Fault with motor hall sensor inside
Bring your Pedelec to your dealer or to a
specialist to have the error fixed.
10
The motor temperature reaches to
the max protection value
Stop the e-bike for a rest.
12
Fault with current sensor inside
controller
Bring your Pedelec to your dealer or to a
specialist to have the error fixed.
13
Fault with temperature sensor inside
battery
Bring your Pedelec to your dealer or to a
specialist to have the error fixed.
21
Fault with wheel speed detecting
sensor
Bring your Pedelec to your dealer or to a
specialist to have the error fixed.
22 BMS communication fault
Bring your Pedelec to your dealer or to a
specialist to have the error fixed.
25 Torque sensor torque signal fault
Bring your Pedelec to your dealer or to a
specialist to have the error fixed.
26 Torque sensor speed signal fault
Bring your Pedelec to your dealer or to a
specialist to have the error fixed.
30 Communication fault
Bring your Pedelec to your dealer or to a
specialist to have the error fixed.
Note: Error Code 10 will probably appear on the
dispaly when the e-bike is climbling for a long
time. This indicates that the motor temperature has
reached the protection value, in which case the user
needs to stop the e-bike for a rest. If the user con-
tinues to run the e-bike, the motor will automati-
cally cut off the power.
ERROR CODE DEFINITION