Bailey Approach - Precautions; Operating Instructions; Changing the LPG Cylinder; Hose Change

Precautions
Make sure that cooking appliances are
switched off before you move the Motorhome.
All gas appliances in your Motorhome can have
their gas supply individually isolated by turning
off the relevant tap. The tap is either located
on the centrally positioned gas manifold or
directly beside the appliance.
Some industrial LPG appliances operate
at high pressure and require a ‘high
pressure’ regulator. This often has an
adjusting handle on it. Never use such
a regulator on a Motorhome.
• Always ensure that the gas system is
inspected/maintained at least every 12
months.
• In the event of a re ensure all occupants
evacuate the Motorhome via the nearest
escape route.
• If you suspect a gas leak then immediately
turn off the supply of gas at the yellow
isolation tap located below the regulator
in the gas box. Then turn off the gas valve
on the gas cylinders. When this has been
completed the system must be inspected
by a competent person.
• Never use gas cylinders located outside the
Motorhome gas box. Do not use any gas
extension hoses.
• Never replace your regulator with one that
does not conform to EN12864 Annex D as
this does not comply with EN1949.
Operating Instructions
Start UP
• Open cylinder valve (no 1)
• Firmly press the hose rupture protection
(green button No 2) on the high pressure
hose.
• If necessary (e.g. after a new installation or
after inadvertently striking the gas cylinder
against the gas pressure regulation
system,) hold the reset button (No 3) in for
at least 5 seconds before slowly releasing
the green button. (Crash sensor triggering
element reset) on the MonoControl CS.
Some cylinder valves differ including
products tted with push on connectors
or something similar.
Changing the LPG Cylinder
Please use the included spanner to attach
and remove the high pressure hose from the
cylinder. It will help to generate the necessary
tightening torque and will prevent damage to
the screw xings by over-tightening.
Residual gas: do not smoke, avoid open
ames.
• Close the empty gas cylinder’s valve
• Remove the high pressure hose from the
gas cylinder
• Attach the high pressure hose to the full
gas cylinder.
• Open the full cylinder’s valve.
• Press the hose rupture protection.
At any time after making changes, check the
hose connection to the cylinder valve for leaks
using a leak detector spray or a soapy solution.
Hose Change
Follow the above instructions concerned with
changing the LPG Cylinder.
Residual gas: do not smoke, avoid open
ames.
• Close gas cylinder valve
• Remove the high pressure hose from the
gas cylinder and from the regulator inlet
When performing a hose change please
ensure that the ‘O’ ring provided with
the hose is correctly installed and not
damaged.
35
5
CONNECTION OF SERVICES- The Gas System
CONNECTION OF SERVICES- The Gas System
i
!
!
!