compartment.
Only use drinking water.
Shutting off the refrigerator
• Press the “MODE” (s.4.3) button to switch
off. Keep button pressed for 3 seconds. The
display disappears and the appliance is fully
switched off.
• Release the locking mechanism of the door
lock by pushing it and shift it to the front.
If the door is shut in this position, a small
gap is nevertheless kept open to prevent
formation of mildew.
• If the refrigerator is to be taken out of
service for an extended period of time,
close the on-board shut-off valve and the
cylinder valve.
Defrosting
• As time goes by, frost builds up on the ns
inside the refrigerator. A layer of frost
thicker on one side may occur and does not
represent a malfunction. When this layer of
frost is about 3mm thick, the refrigerator
should be defrosted.
• Switch off the regulator, as described in
section “Shutting off the refrigerator”
• Remove all food and the ice cube tray
• Leave the refrigerator door open to allow air
to enter and prevent formation of mildew.
• After defrosting (freezer compartment
and ns free of frost), wipe both cooling
compartments with a cloth.
Water thawing in the main compartment
of the refrigerator runs into an
appropriate container at the back of
the refrigerator. From there the water
evaporates.
The layer of ice must never be removed
forcibly, nor may defrosting be
accelerated using a heat source!
Winter operation
In winter, check that the ventilation grilles
and the exhaust duct system (1) have not been
blocked by snow, leaves, etc.
Information on failure display and trouble-
shooting.
If a malfunction occurs, the indicator LED
“Failure” (1) ashes and LED (2) simultaneously.
If the failure is not resolved, it repeats after 1
hour.
Status messages on the display
LED is ashing
230V mode: “230V” is not available or voltage
is too low
LED is ashing
12V mode: “12V” is not available or voltage too
low.
LED is ashing.
Gas/Auto mode: Flame not ignited.
All temperature setting LEDs are ashing
Temperature sensor defective, refrigerator
works on mid temperature setting.
LED +All temperature setting LEDs are
ashing
230V- Heating element defective.
LED + all temperature setting LEDs
are ashing
12V- Heating element defective.
74