Introduction
The Thetford Cassette Toilet is a high quality
product. The toilet forms an integral part of
your caravan bathroom, thanks to its functional
design which combines modern styling and
ease of use.
The C-260 Cassette Toilet is manufactured
from high quality synthetic materials which
makes it a durable, user and maintenance
friendly toilet.
The toilet is made up of two parts: a
permanently xed part and a Waste Holding
Tank that is accessible from the outside. The
removable Waste Holding Tank is located under
the toilet bowl and can be removed via a door
on the outside of the Caravan. The Thetford
Cassette Toilet is the solution to the sanitary
problem in your caravan.
The operating instructions cover Thetford
Cassette Toilet C262 CWE
Parts
1. Cover
2. Seat
3. Swivelling toilet bowl
4. Blade handle to open and close blade
5. Control panel
5b.Waste holding tank level indicator
6. Pull handle
7. Pour out spout
8. Cap with measuring cap
9. Automatic pressure release vent
10. Vent button
11. Sliding cover
12. Blade opener
13. Waste holding tank mechanism
14. Wheel
15. Service door
16. Water ll door
17. Console with ush water tank
18. Filter for electric ventilator
19. Location waste pump- out system
Preparing for use (standard)
• Open the access door on the outside of your
Caravan.
• Remove the Waste Holding Tank by pulling
the safety catch (which holds the tank in
place) upwards.
• Pull the Waste Holding Tank outward to the
stop. Tip it slightly and take the tank fully
out.
• Place the tank upright and turn the rotating
emptying spout upwards. The emptying
spout ensures that the tank can be easily
and hygienically emptied.
• Remove the cap, with the measuring cup
inside, from the emptying spout and pour
the correct dosage of Thetford toilet uid
(see product label) into the holding tank.
This avoids unpleasant smells and keeps
the inside of the tank clean. Next add
approximately 2 litres of water - enough
to ensure that the bottom of the Waste
Holding Tank is covered. Screw the cap back
onto the emptying spout and turn back to
its original position. The Emptying Spout
Measuring Cap is supplied inside the toilet.
Never add toilet uid directly via the blade
or the toilet bowl as this could damage the
lip seal of the Waste Holding Tank. Always
pour the uids via the emptying spout. The
lip seal is the water tight seal around the
top of the tank.
• Slide the Waste Holding Tank back into its
original position via the access door. Make
sure that it is secured with the safety catch.
77
To Next Page
Loading...
