Bailey Approach - Heating with Gas

Heating with gas
Do as follows to activate heating with gas.
If both electricity and gas are selected,
electricity is given priority.
• Start the gas operation by pressing On (On
is activated).
• The settings are ready and the boiler is
working at set temperature.
• In order to switch off gas operation, press
Off.
The tool menu - functions
When you are in the tool menu, you can use
the tools described below. Step between the
various tool elds by pressing the up or down
arrow symbols. You can always leave the tool
menu with the MENU button.
Functions marked with * indicate that
the symbol for the function is displayed
on the control panel even if the
accessory is not installed!
1. Arrow symbols
Step between the various tool elds by
pressing the up or down arrow symbols. You
can always leave the tool menu with the MENU
button.
2. Clock
The clock must be set if automatic night-time
mode or automatic start is to be used. If 12V
voltage is lost, the clock will be reset and
correct time will no longer be displayed. This is
prevented with an optional AA battery backup.
3. Automatic night-time mode
This function is used when you want
to programme the central heating to
automatically lower the temperature at night
and raise the temperature in the morning.
4. Starting the boiler automatically
This function is used to start the boiler
automatically at a later point of time. With
automatic start, the boiler works for 24 hours
and then stops. After that, it repeats the
automatic start once a week; at the same day
and time, as long as the function is activated.
For automatic start to function, the On/Off
button must be set in the OFF position.
5. Constant pump operation
Cont.: With this function selected the pump is
permanently on. (NB., this function limits the
supply of hot water, particularly when there is
a low heating requirement)
Therm: With this function selected the pump
is controlled by the panel/room sensor. This
is the normal operating mode for heating the
vehicle and obtaining a normal supply of hot
water. Factory setting is Therm.
6. *Pump Auto / 12V
In the Auto mode, the 230V pump operates,
and when 230V is disconnected, the 12V pump
starts. In 12V mode, the 12V pump is used even
if 230V is connected. The Auto function is
activated in the factory setting.
51
6
FITTED EQUIPMENT- The Alde Heating System
FITTED EQUIPMENT- The Alde Heating System
i