Bajaj Pulsar 135 LS User Manual

General Maintenance Information
19
Front Brake Fluid Level
• Front brake fluid master cylinder reservoir is located
near RH switch on handle bar.
• To check oil level, keep the vehicle on Centre stand
with handle bar in straight ahead position.
• Always ensure that brake fluid level is above ‘MIN’
mark given on inspection window.
• Use only DOT 3 or DOT 4 brake fluid (from sealed
container) to top up if required.
It is advisable that brake fluid should be replenished at
evert 30,000 Kms or once in two years which ever
occurs earlier.
Monsoon Care :
• It is suggested to customer to take appropriate care
in area of heavy monsoon or high rainfall area. The
appropriate surface preventive coat to avoid rusting /
poor surface finish on account of adverse
atmospheric conditions.
• Vehicle cleaning to be done with soft & clean wet
cloth to avoid scratches on painted parts.
• Clean & lubricate all the important parts as detailed
in a periodic maintenance chart.
• Do not apply direct water jet on painted, electrical /
electronic parts.
• Do not obstruct engine cooling by adding mud
protection sheet from front.

Bajaj Pulsar 135 LS Specifications

General

Engine Type	4-Stroke, DTS-i, Air Cooled, Single Cylinder
Displacement	134.66 cc
Max Power	13.5 PS @ 9000 rpm
Max Torque	11.4 Nm @ 7500 rpm
Transmission	5-speed
Fuel System	Carburetor
Front Brake	240 mm Disc
Rear Brake	130 mm Drum
Fuel Tank Capacity	8 liters
Kerb Weight	122 kg
Gearbox	5-speed
Bore x Stroke	54 mm x 58.8 mm
Compression Ratio	9.8:1
Overall Length	1995 mm
Overall Width	765 mm
Overall Height	1045 mm
Wheelbase	1325 mm
Ground Clearance	165 mm
Front Suspension	Telescopic
Rear Suspension	5-way adjustable, Nitrox shock absorber
Clutch	Wet, Multi Plate
Front Tyre	2.75 x 17
Rear Tyre	100/90 x 17
Starting	Kick and Self Start