13
Error messages with E
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers is
found on the side of the oven door. You can make a note of the
number of your appliance and the telephone number of the
after-sales service in the space below to save time should it be
required.
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
This appliance corresponds to the standards EN 55011 and
CISPR 11. It is a Group 2, Class B product.
Group 2 means that microwaves are produced for the purpose
of heating food. Class B states that the appliance is suitable for
private households.
Technical data
A particular type of heating or
power level cannot be set.
The temperature, microwave power
level or combination setting is not pos-
sible for this type of heating.
Choose permitted settings.
The appliance can be set, but does
not heat up. A "D" appears in the
display panel
The appliance is in demo mode. To deactivate demo mode:
1. Select the › Hot air heating type and a tempera-
ture of 50 °C.
2. Touch and hold the @ button for at least
4 seconds, then release.
The display panel flashes.
3. Touch the @ button again within 4 seconds.
The "D" disappears from the display panel.
Demo mode is deactivated.
Problem Possible cause Remedy/information
Error message Possible cause Note / remedy
“‚ or “…
The thermal safety switch-off function has been activated. Call the after-sales service.
“ƒ
The automatic safety switch-off function has been activated. Touch any button or turn the rotary selector.
“„
The oven is malfunctioning. Call the after-sales service.
“‚‚
Moisture in the control panel. Allow the control panel to dry.
“‚ˆ
Rapid heating has failed. Call the after-sales service.
E no.
FD no.
After-sales service
O
Power supply 220 - 230 V, 50 Hz
Total connected load 3350 W
Microwave power setting 900 W
Microwave frequency 2450 MHz
Grill 1750 W
Hot air 1750 W
Fuse 16 A
VDE approved yes
CE mark yes
To Next Page
Loading...
