TP200 USER GUIDE 42375 Rev A1
28
27
Balboa Water Group | Your Single Source Solution
Treat the wood.
This message may appear every 180 days.
Wood skirting and furniture should be cleaned
and conditioned per the manufacturers
instructions for maximum life.
Change the water filter.
This message may appear every 360 days.
Filters should be replaced occasionally to
maintain proper spa function and
sanitary conditions.
Change the spa water.
This message may appear every 90 days.
Change the water in the spa on regular
basis to maintain proper chemical balance
and sanitary conditions.
Clean the spa cover.
This message may appear every 180
days. Vinyl covers should be cleaned and
conditioned for maximum life.
Test the GFCI or RCD.
This message may appear every 30 days. The
Ground Fault Circuit Interrupter (GFCI) or
Residual Current Device (RCD) is an important
safety device and must be tested on a regular
basis to verify its reliability.
Every user should be trained to safely test
the GFCI or RCD associated with the
hot tub installation.
A GFCI or RCD will have a TEST and
RESET button on it that allows a user to verify
proper function.
Warning:
If freezing conditions exist, and the spa has
powered down, the GFCI or RCD should be
reset immediately or spa damage could result.
If the GFCI or RCD does not reset and freezing
conditions exist, drain the spa of all water until
the spa is functional again.
The end user should always trained to test and
reset the GFCI or RCD on a regular basis.
Check the ozone and/or UV generator.
This message may appear every 360 days.
Check your ozone and/or UV generator per
your spa manufacturer’s instructions.
Change the mineral cartridge
as needed.
Install a new mineral cartridge per you spa
manufacturer’s instructions.
Your spa needs a service check.
This message may appear every 365 days.
Contact your service organization for a
service check.
To Next Page
Loading...
