TP200 USER GUIDE 42375 Rev A1
2
1
Balboa Water Group | Your Single Source Solution
RED LCD CHARACTERS
Red indicates flashing or changing characters. For example, these
segments flash when you press the TEMP button to change the Set
Temperature.
BLUE LCD CHARACTERS
Blue indicates an alternating message or a progressive message.
When you view Time-of-Day, this progressive message appears.
TEMPERATURE BUTTON
The TEMP button icon indicates an “action.” For example, pressing
the TEMP button initiates any one of the following actions: adjusting
the Set Temperature, menu navigation, setting the Filter Cycle Time,
setting the Heat Mode, etc.
LIGHT BUTTON
The LIGHT button icon indicates navigation or a selection.
HOLLOW DOTS
Hollow dots indicate that your last setting was not saved. For
example, when you set a feature such as Time-of-Day, you need to
press the LIGHT button to save your setting. If you do not press the
LIGHT button, the Main Screen will appear automatically after a few
moments, and your last setting will not be saved.
SOLID DOTS
Solid dots indicate that your last setting will be saved. For example, if
you change the Set Temperature and pause a few moments, the Main
Screen will appear automatically, and your setting will be saved. The
same applies to other features that will be discussed later.
TABLE OF CONTENTS SEQUENCE KEY
SEQUENCE KEY
PANEL INTERFACE & TERMINOLOGY
MAIN MENUS & NAVIGATION
CHANGE SET TEMPERATURE
INVERT DISPLAY
SET FILTER CYCLE DURATION
SPA BEHAVIOR
HEAT MODES
FILL IT UP!
PANEL MESSAGES
17 GENERAL
19 HEATER RELATED
21 TEMPERATURE SENSOR RELATED
23 MISCELLANEOUS
24 CONTROL SYSTEM RELATED
26 REMINDER
To Next Page
Loading...
