Banner AMG - Page 11

July 17, 2023
Asset Monitoring Gateway With SNAP ID Instruction Manual


11
Thresholds
Allows the user to configure alarm states for the selected device.
Threshold 1 (Yellow)indicatesawarning alarm.
Threshold 2 (Red)indicatesacritical alarm.
These alarm states are reflected in the group area (if the sensor has been grouped) by the asset icon changing color to
reflect the alarm state. Alarms from any attached device are also indicated on the pendant light on the top left corner of
theenclosure.Criticalalarms(red)takepriority,followedbyyellow,thengreenfornormaloperationindication.
Set thresholds for specific registers by touching the thresholds in the table and manually typing in an alarm value. This
promptstheAMGtoenabletheModeoperator.Tapthemodeoperatortobrowsethroughtheoperandsandselectthein
tendedone.SelectSavewhenyouaresatisfiedwiththealarmdata,andthenYesforconfirmation.Thresholds savedap
pears at the bottom of the screen after the settings are saved.
Sensor List Thresholds screen
Operations screen
© Banner Engineering Corp.