Banner AMG - DXM HTTP Status and Network Configuration

July 17, 2023
Asset Monitoring Gateway With SNAP ID Instruction Manual


17
DXM HTTP Status
Contains cellular signal strength (if applicable) along with cloud push statistics. By default, the AMG is configured with
Push disabled (shown at the bottom of the screen). When cloud push is turned on (via the DXM Configuration Screen)
thestatuschangesinthiswindowtoPush Enabled.
DXM HTTP Status screen
Network Configuration
Bydefault,theEthernet ModeisconfiguredwithanIPaddressof192.168.0.1usingtheinternalXMLconfigurationfile.
DXM Network Configuration screen
TomanuallychangetheIPaddress,toggletheEthernet ModetoStatic.TouchtheStaticIPAddressfieldsandenteran
appropriatevalue.PressSavetoapplythenewsettings.ToggletheEthernet ModefieldbetweenStatic,DHCP,andXML
Config(defaultsettingsandnotintendedtobeuserconfigured).
IMPORTANT: BannerEngineeringCorp.doesnotrecommendmanuallychangingthedefaultIPset
tingsoftheinternalXMLconfigurationfile.ThiscanbedetrimentaltotheprogrammingoftheAMG.
HMI Utilities Screen
HMI Details
Contains firmware and serial numbers of the internal HMI.
© Banner Engineering Corp.