Banner AMG - Configure HMI to Push Information to Cloud

July 17, 2023
Asset Monitoring Gateway With SNAP ID Instruction Manual


22
Configure the HMI to Push Information to the Cloud
IMPORTANT: Always create a new gateway with the BannerCDS system and commission applicable sen
sors before turning Cloud Push Enable to Yes. Failure to do so can result in long wait times for the web
site to autodetect.
EntertheAMGserialnumberfoundintheUtilities›DXM Detailsscreen.
6.
ClickSave.
7.
OntheHMI:GotoDXMUtilities›DXM Configurationtoenablecloudpushing.
1.
ChangetheThreshold Filtertoanumbergreaterthan0(3isrecommended).
2.
Verifyyourdevice'sPush Communication Modeisaccuratetoyourmodel.
3.
ToggleCloud Push EnabletoYes.
HMI Utilities screen
4.
ChangetheCloud Push Intervaltoadesiredtime.
Thedefaultpushintervalis600seconds(10minutes).
5.
PressSaveandconfirm.TheAMGpushesimmediatelyuponconfirmation.TheusercantracktheHTTPdatawithin
theDXM Utilities›DXM HTTP Statusscreen.
6.
© Banner Engineering Corp.