(2) Use the numerical keypad to enter the number of the menu item.
(3) To enter the menu item, press
the key.
(4) For entering the desired parameter you have two options:
a) Use the arrow keys as we did in the previous section; or
b) Use the numerical keypad to enter the numerical short-cut code.
(5) And just as in the previous section;
a) To confirm your selection, press and it will save your setting and bring you back to the main menu.
b) To cancel your changes, press and it will reset that menu item and bring you out of the menu entirely.
(6) To exit out of the menu at any time, press the key.
(7) All further examples and procedures in this manual will use the numerical menu short-cuts.
+ 1: Quick access to Banks selection, up to 10 banks are stored, each bank stores 100 channels;
+ 2: Quickly enter the Scan Settings. You will be able to set the VFO frequency range, Scan mode, Scan Sub-Code, Scan Memory;
+ 3: Quickly enter the Radio settings (general settings of the radio);
+ 4: Quickly enter GNSS position system settings (GNSS switch, time zone setting, position mode setting)
+ 5: Quick access to Program Channel (Alias, TX and RX Frequency, TX Power, Bandwidth, Display mode, Channel Memory and Channel delete);
+ 6: Quickly query the Fall Down settings;
+ 7: Quickly query the radio information (ANI ID, Firmware version, Hardware version);
7.3 Radio Settings
(1) Step frequency (Step) –
+ 1
This function lets you select the desired frequency step.
The selectable steps are the following: 2.5K/5.0K/6.25K/10K/12.5K/20K/25K/50K/100K.
Note: in channel mode, this function cannot be modified.
(2) Squelch level (Squelch) – + 2
Thanks to this function you can adjust the squelch in 5 different levels:
• OFF: opened squelch. With this setting, the radios will detect all signals, also the weakest ones, but will also receive the background noise or undesired
signals.
• Levels 1- 5: level 1 (lowest squelch level), level 5 (highest squelch level).
If the squelch is set to the highest level, the radio will receive the strongest signals only.
(3) Power save (Power Save) – + 3
When the radio is in standby, the power saving function reduces battery consumption. Turning on will be more power efficient, but you may miss the first few
To Next Page
Loading...
