(12) Keypad beep (Beep) – + 12
When this function is enabled, every time a key is pressed, you will hear a beep tone.
(13) Backlight (Backlight) – +13
With this function you can adjust the auto off time of the display backlight.
Always: The backlight is always on.
5S-20S adjustable.
Note: This function is valid when turn off the power save.
(14) Power on image (Power on Display) – + 14
With this function you can set the display mode when the radio is turned on. Available options:
• PICTURE: Display the preset startup picture.
• VOLTAGE: The power voltage is momentarily displayed.
(15) Dual Watch Operation (Dual Watch) – + 15
When this function is activated, you can receive the frequency of channel A and channel B at the same time.
If a signal is detected, the or pointer will blink on the corresponding channel or frequency.
Note: In Dual Watch operation mode, the 'D' icon will be displayed on the top line of the screen, you can freely change the parameters of AB
channel or frequency.
(16) Auto Keypad Lock (AutoLock) – + 16
When this feature is activated, the keypad will be automatically locked after 10s; this prevents accidental pressure of any keys.
The keypad lock can be manually activated/deactivated through the keypad: keep pressed
.
(17) Alarm Mode (Alarm Mode) – + 17
This function can set the tone alarm/code alarm/site alarm of the radio.
Keep pressed the [SK3] key for 3 seconds to start the alarm tone.
The following three options can be selected:
• Site: the speaker emits an alarm tone but the radio doesn’t transmit;
• Tone: the speaker emits an alarm tone and the radio transmits it;
• Code: the speaker emits an alarm tone and the radio transmits it followed by ANI-ID code.
(18) Local Alarm Tone (Alarm Tone) – + 18
Whether to emit an alarm whistle locally when the emergency alarm function is triggered.
(19) ANI-ID (ANI-ID) – + 19
To Next Page
Loading...
