ON
Disables the [PTT] button on a channel that is already in use.
The transceiver will sound a beep tone and will not transmit if the [PTT]
button is pressed when a channel is already in use.
Specifies the difference between the TX and RX frequencies
17 Direction
TX = RX (simplex). Disable access to repeaters in VFO/Frequency mode
Plus
Plus frequency shift direction. TX will be shifted higher in frequency than
Minus
Minus frequency shift direction. TX will be shifted lower in frequency than
16 CH_Memory CH001-CH100
This menu is used to either create new or modify existing channels (1
through 100) so that they can be accessed from MR/Channel Mode.
17 CH_Delete CH001-CH100
This menu is used to delete the programmed information from the
specified channel (1 through 100) so that it can either be programmed
6 Fall Down
1 Trigger Mode
Disable Man Down Function
Tile
When the radio tilts at or over the preset Trig Tilt Gradient over the Trig
Entry Delay Time, it will enter the Man Down mode automatically.
Motionless
When the radio is motionless or takes uniform rectilinear motion (reference
object: the ground) over Trig Entry Delay Time, the radio will enter the Man
Tile or Motionless
When the radio tilts at or more than Trig Tilt Gradient or is motionless over
Trig Entry Delay Time, it will enter the Man Down mode automatically.
2 Tilt Angle 75°, 60°, 45°, 30°
The radio will have real-time detections of its tilt degrees off the vertical.
When the radio's degree off the vertical exceeds Tilt Gradient, the radio
will enter Man Down mode automatically.
3 Cur dly time 10 – 255s
This option allows users to set the inverval between radio falling down and
alarm activation. The alarm will not be activated if users place the radio
upright within the interval.
4 Pre cue time 10 – 254s
After you Man Down the radio and within Trig Entry Delay Time before the
emergency mode is activated, the radio will pre-alert you to the situation.
To Next Page
Loading...
