Barco DP2K-12C - Removal of the Xenon Lamp

4. Lamp & Lamp House
Image 4-4
Release lamp house
4. Take the lamp house by the handles and p ull it out of the projector.
Caution: Be aware of the weight of the lamp as semb ly. Tak e the necess ary pre cautions to avoid personal injury.
Image 4-5
Remove lamp house
5. Place the lamp house on a stable support.
While starting up the projector, the electronics detect if a lamp is ins talled. If no lamp is installed, i t is not
possible to start up the projector.
4.3 Removal of the xenon lamp
WARNING: DO NOT P ERMIT UNAUTHO RIZED PERSONNEL TO PERFORM O R ATTEMPT ANY PHASE OF
XENON LAM P HA NDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONN EL
ARE ALLOWED TO HANDLE THE XEN ON LAMP.
WARNING: This procedure may only be performed by qualified technical service personnel.
24 R5905050 DP2K C-SERIES 10/07/2012