49R5905752 /16 DP2K C
Image 4–17
6. Insert the anode socket into position as illustrated.
Caution: Avoid any tension on the anode wire, ensuring there is no mechanical stress on the
lamp.
Image 4–18 Anode socket installation
7. Reinstall the UV blocker assembly as illustrated. Make sure that the xenon lamp is properly supported by
the lamp supporting mechanism in the centre of the UV blocker. Use the opening at the side of the Lamp
House to guide the supporting pin of the xenon lamp into the anode supporting mechanism.
Image 4–19 UV blocker installation
8. Secure the UV blocker by fastening the four retaining thumbscrews as illustrated.
Note: Please ensure that the thumb screws turning wires are flush with the cover or interference
will occur while inserting the lamp house into the projector.
Lamp & Lamp House
To Next Page
Loading...
Need help?
General
