Barco G62 Series User Manual

77R5914653 /02 G62
Image is reversed
• To reverse the image, enable rear projection by selecting “Installation > Orientation > Direction > Rear
Projection” from the OSD menu.
The projector stops responding to all controls
• If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before
reconnecting power.
If the remote control does not work
• Check if the operating angle of the remote control is pointed within ±30° (front and back) to the remote
receivers on the projector. Make sure there are any obstructions between the remote control and the
projector.
• Check the remote batteries. Make sure batteries are inserted correctly. Replace the batteries if they are
used up.
• Ensure you have set the correct IR code to the remote control. See “Remote Settings“ in the chapter
“Remote Setup”, page 60.
12.2 LED indication chart
Overview
1 2 3
Image 12–1
1 AV Mute LED
2 Status LED
3 Light LED
Explanation
Message
Light LED
Status LED AV Mute LED
Green
Orange
Red Green
Orange
Red Green
Orange
Standby State
Power on
(Warm up)
Flash-
ing
Power on & Laser
diode on
Steady Steady Steady
AV mute is off
(Image is displayed)
Steady Steady Steady
AV mute is on
(Image is black)
Steady Steady Steady
Troubleshooting

Barco G62 Series Specifications

General

Brand	Barco
Model	G62 Series
Category	Projector
Language	English